The UV photolysis purification equipment for malodorous gas treatment equipment is selected according to the air volume. First, the treatment air volume of the equipment is mainly determined. The second is to determine the treatment effect of the equipment. According to the maximum treatment concentration of the UV photolysis purification equipment, the air volume of the purification system can be selected, and the UV photolysis purifier with the appropriate air volume can be selected.
UV photo-oxygen catalytic equipment generally needs to be installed in a well-ventilated place, and it must be used in the presence of natural light sources, so that the catalyst inside the equipment can be in contact with the ultraviolet rays in the natural light source to generate Ozone substances with oxidizing effect, so that an ideal oxidation treatment effect can be achieved for organic waste gas. The main application technology of photocatalytic equipment is what we often call photocatalyst technology. This technology requires the use of UV lamps with special wavelength bands for installation and design. Workshops with different air volumes have a more important impact on the number and arrangement of UV lamps.
Under normal circumstances, the organic waste gas can be collected into the interior of the photocatalytic equipment by the pressure of the fan, so that the waste gas with relatively high concentration will start to split and purify under the influence of the strong ultraviolet light beam. The advantage of this kind of equipment is that it can be installed and used in an environment with low concentration and high air volume, and it can achieve a relatively ideal treatment effect. No special maintenance and management is required in daily use. Regular inspections can be done to check the specific conditions of the lamps and the use of catalysts, but if you are not a staff member, do not go to the work area to avoid causing some hidden dangers to the normal operation of the equipment.
At present, UV photo-oxygen catalytic equipment has been used in the treatment of various odorous gases. The treatment of odorous gases does not require pretreatment, and work such as heating and humidification that everyone is more familiar with does not need to be carried out. In order to meet the actual needs of factories in different regions, the equipment is made of high-quality 304 stainless steel, which can have a good effect in terms of fire resistance and corrosion resistance, and can improve the service life of the equipment to a certain extent.